Measurements

Equipment size 720x500x580mm

Pressing area 300x300x100mm Structure

12mm aluminum sheet

30x30 aluminum structural profiles

4mm crystal polycarbonate (protection)

6mm HDPE (casing) Pneumatics

Pressure regulator up to 8.5 Bar with pressure gauge and PU8 connection

5/2-way 24VDC pneumatic solenoid valve with PU6 connection and 1/8” silencers

PU6 ¼” flow regulating valve Movement System / Actuators

20mm linear rail – 20mm flanged slide (table)

Ø 20mm x 250mm linear guides – linear bearing with flange (press)

Ø 25mm x 300mm double-acting pneumatic cylinder with magnetic piston (Table)

Double-acting pneumatic cylinder Ø 63mm x 100mm with magnetic piston (press) Control / Safety

PLC with Delta TP04 HMI relay

300mm light curtain (Cloweit) 40mm spacing

Digimec DPX257 T4 and DPX257 T10 safety relays

Two-hand control Operation

The controller allows adjustments to the operating time (Table advance/return and press advance/return)

Operation counter

Manual / automatic operation

I/O screen (inputs/outputs)

A) Equipment: Full manufacturer's warranty for a period of 12 (twelve) months after the shipping date. The shipping and return of parts under warranty to the manufacturer are the responsibility of the customer. Defects caused by improper use are excluded from the warranty. Full parts supply warranty for 10 years. B) Labor: 12 (twelve) months after the shipping date. Defects caused by improper use are excluded from the warranty. For equipment installed outside the municipality of Manaus, the travel and accommodation expenses of ATROM's technical personnel, incurred during equipment installation, training courses, and technical assistance calls, will be the responsibility of the customer. Service Limitations: Technical assistance within the service warranty period will be free of charge during business hours - MON - FRI from 8:00 AM to 5:00 PM. Services performed at the request of a technical call outside business hours will be charged per hour of actual work, regardless of the call condition. Coverage: All parts and components subject to natural wear and tear, or wear caused by failure or lack of preventive maintenance and conservation, or by operational errors, or by intervention of third parties not qualified and not authorized by the manufacturer or supplier, are considered "out of warranty". Within the group of wear parts and components are all units of movement, friction, constant actuation and under the direct influence of an external supply source, such as compressed air, vacuum and water. The most common are: chains, guides, pulleys, toothed sprockets, belts, sheaves, bearings, bushings, air filters, filters in general, lenses, nozzles, limit switches, ejector valves, solenoid valves, pneumatic pistons, among other parts that are demonstrably parts and components subject to movement and wear. For services applied within this defined group, the technical hours spent on repair or replacement will be charged separately according to the standard technical hour rate table in effect at the time. Installation: Installation will be performed by an ATRON technician at no additional cost to the customer; however, for equipment installed outside the municipality of Manaus, travel, food, and accommodation expenses will be the customer's responsibility.